For years I have worked on building a great amp for my
favorite tube, the 300B. I have built single ended, push pull, and parallel
single ended. In the end I think only the SE 300B has the magic that the tube is
known for. I know many companies offer pumped up 300B's with 25-50 watts of
power. Most of them use circuits that favor power over the lush beauty of the
300B. I have chosen a different route.


To start with I have studied many great designs of the
past. Things were done differently in the 20's-30's. Considered ancient, useless
designs by most, I have utilized many parts of these old designs because of the
sound they bring. Back in the early times of radio most were powered by
batteries due to the lack of electrical lines. This is why the power for a tube
amp is called B+. Later, as AC electricity became more common, most units ran on
outside power. What does this have to do with my amp? Well, the method used to
power the filament inside the tube makes a huge sound difference. DC is
generally more quiet but less rich. AC can present hum problems but I feel it
has a nicer, richer sound which can be made more detailed by the addition of the
correct parts. It is for this reason that I have chosen AC to heat the tubes.


The base of any tube amplifier is the power supply. This
is what gives each circuit the correct amount and power of electricity. The
incoming AC power must be converted to DC and then back to AC in the correct
wave form. This must be done with as much filtering as possible. You do not want
the original AC to be embedded in the music signal. To do this in the old days
designers used multiple choke transformers and very small (4 uf) capacitors.
Today capacitors are available in very large numbers. Most companies use these
instead of chokes because capacitors are much cheaper than transformers. This
leads us to the 274B rectifier tube. Since it is a very old tube it can not
withstand first capacitors over 4uf. I love the sound of the 274B and know that
it was usually used by Western Electric for rectification. That is what I use,
old school. The sound of choke filtering over capacitor filtering is very
dramatic. Capacitors, especially electrolytic, are not a good sound. I use only
small value film capacitors in the power circuit. Again, I am mixing the good
part of old school with modern parts to achieve a total sound with no hum. I use
a torrid transformer rated at 1/2 amp which results in a very large head room.
Dynamics must be heard to be believed. s


The amplifying circuit design is also from the past. It
is a very simple design using only a few audiophile parts. It uses a
potentiometer to reduce hum from the AC filaments. When adjusted properly I have
no audible hum from my 96db speakers. It is all hard wired using high end parts.
NO circuit board is used.


The tubes that I am using are some of the best available.
The 300B is a 1:1 replica of the original. The 274B is also patterned after the
original Western Electric tube. These tubes belong together and deliver a large,
detailed sound stage. The input tube flavors the sound of the entire amp. It is
for that reason that I use a CV181 or Russian 1578. The CV181 is an
improved version of the 6sn7. Thi 6sn7 is again a tube that was around in the
old days. It has been updated to deliver superior sonic virtues and called the
CV181. I also love the very rare Russian 1578. It is a tube that was used in the
Mig fighter radar as well as Russian nuclear reactors. You can purchase my amp
with either tube or even both for the tube rollers out there.


Finally the output transformers are reputed to effect the
sound more than any other component. I can offer the highly regarded Electra
Print as the standard unit. Other brands can be specified at additional cost.
The extremes of sound production are recreated with a good output transformer.
The subtle details, transients, and dynamic content of your precious recordings
will not be lost with this amp.

Manufacturer direct price

$5999.99